Axeon R1-Series Manuel d'utilisateur Page 7
- Page / 58
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
MKTF -
211
CONCENTRATE (WASTE WATER) CONNECTION
Locate the
1” or 3/4” connection (Depending on the unit)
the concentrate line
to an open drain in a free and unrestricted manner (no backpressure).
that an air-
break be used on the concentrate line to prevent siphoning of water from the pressure vessels
when the system is in standby.
CAUTION: ANY RESTRICTIONS OR BLOCKAGE IN THE DRAIN LINE CAN CAUSE
BACKPRESSURE, WHICH WILL INCREASE THE SYSTEM’S OPERATING PRESSURE. THIS CAN
RESULT IN DAMAGE TO THE SYSTEM’S MEMBRANES AND COMPONENTS.
ELECTRICAL
The motor used on the R1-
Series
220/460 Volt, 50/60 Hertz, 1 P
hase
cord.
E
nsure that the electrical circuit supplying the system is compatible with the re
R1 model you are installing.
NOTE: IT’S RECOMMEND
ED
ACCORDANCE WITH LOCAL AND NATIONAL ELECTRICAL CODES (NEC).
WARNING: TO REDUCE THE RISK OF ELECTRICAL SHOCK, THE INCOMING
SUPPLY MUST INCLUDE A PROTECTIVE EARTH GROUND.
R1-Series
systems are typically controlled with a liquid level switch in a storage tank. The liquid level
switch turns the system on when the water level in the tank drops, and off when the tank is full
level switches can be obtained by your local dealer or distributor. If a liquid level switch is to be used,
install it at this time.
PRE-FILTRATION
R1-Series
systems are supplied with a
when a 10-15 psi differential ex
ists between the two pre
about Pre-
Filtration systems, if required.
NOTE: THE SYSTEM MUST BE OPERATED
PUMP
The pump used on the R1-
Series systems is of the
Follow these guidelines to ensure proper operation of the pump:
The pump must NEVER
the pump.
7
211
CONCENTRATE (WASTE WATER) CONNECTION
1” or 3/4” connection (Depending on the unit)
labeled concentrate
and
to an open drain in a free and unrestricted manner (no backpressure).
break be used on the concentrate line to prevent siphoning of water from the pressure vessels
CAUTION: ANY RESTRICTIONS OR BLOCKAGE IN THE DRAIN LINE CAN CAUSE
BACKPRESSURE, WHICH WILL INCREASE THE SYSTEM’S OPERATING PRESSURE. THIS CAN
RESULT IN DAMAGE TO THE SYSTEM’S MEMBRANES AND COMPONENTS.
Series
systems are pump and motor combination.
The motor is available
hase
/3 phase. Each R1-Series
system is equipped with a 5 foot electrical
nsure that the electrical circuit supplying the system is compatible with the re
q
uirements of the specific
ED
THAT A LICENSED ELECTRICIAN WIRE YOUR SYSTEM IN
ACCORDANCE WITH LOCAL AND NATIONAL ELECTRICAL CODES (NEC).
WARNING: TO REDUCE THE RISK OF ELECTRICAL SHOCK, THE INCOMING
SUPPLY MUST INCLUDE A PROTECTIVE EARTH GROUND.
systems are typically controlled with a liquid level switch in a storage tank. The liquid level
switch turns the system on when the water level in the tank drops, and off when the tank is full
level switches can be obtained by your local dealer or distributor. If a liquid level switch is to be used,
systems are supplied with a
5 micron sediment filter
. Change the cartridge
ists between the two pre
-filter gauges
. Ask your local deale
Filtration systems, if required.
NOTE: THE SYSTEM MUST BE OPERATED
USING FILTERED FEED
WATER ONLY.
Series systems is of the
multi-stage centrifugal
stainless
Follow these guidelines to ensure proper operation of the pump:
be run dry. Operating the pump without sufficient feed water will damage
07/26/12
and
attach to a drain. Run
to an open drain in a free and unrestricted manner (no backpressure).
It is advised
break be used on the concentrate line to prevent siphoning of water from the pressure vessels
CAUTION: ANY RESTRICTIONS OR BLOCKAGE IN THE DRAIN LINE CAN CAUSE
BACKPRESSURE, WHICH WILL INCREASE THE SYSTEM’S OPERATING PRESSURE. THIS CAN
RESULT IN DAMAGE TO THE SYSTEM’S MEMBRANES AND COMPONENTS.
The motor is available
in
system is equipped with a 5 foot electrical
uirements of the specific
THAT A LICENSED ELECTRICIAN WIRE YOUR SYSTEM IN
WARNING: TO REDUCE THE RISK OF ELECTRICAL SHOCK, THE INCOMING
POWER
systems are typically controlled with a liquid level switch in a storage tank. The liquid level
switch turns the system on when the water level in the tank drops, and off when the tank is full
. Liquid
level switches can be obtained by your local dealer or distributor. If a liquid level switch is to be used,
. Change the cartridge
once a month or
. Ask your local deale
r or distributor
WATER ONLY.
stainless
steel type.
be run dry. Operating the pump without sufficient feed water will damage
- Reverse Osmosis 1
- User’s Manual 1
- This Page Intentionally 2
- Left Blank 2
- TABLE OF CONTENTS 3
- INTRODUCTION 4
- ELECTRICAL 7
- PRE-FILTRATION 7
- MOUNTING 8
- MEMBRANE ELEMENTS 8
- HF4-STANDARD 8
- HF5-OPTIONAL 9
- NF3-OPTIONAL 10
- NF4-OPTIONAL 11
- LC LE-4040-OPTIONAL 12
- MKTF - 211 07/26/12 13
- LC HR-4040-OPTIONAL 14
- SYSTEM IDENTIFICATION 16
- NUMBER IDENTIFICATION 17
- FIGURE 1B 18
- FIGURE 1C 19
- FIGURE 1D 19
- FIGURE 1E 20
- FIGURE 1F 20
- SYSTEM PURGING 21
- INITIAL START-UP 22
- R1-4140, R1-5140, R1-6140 23
- Specifications 23
- FLOW METER 25
- LOW PRESSURE SWITCH 25
- PUMP THROTTLE VALVE 25
- ADJUSTING THE THROTTLE VALVE 25
- MEMBRANE ELEMENT 26
- 07/26/12 27
- FLUSHING THE SYSTEM 28
- PREPARING SYSTEM FOR STORAGE: 28
- PREPARING UNIT FOR SHIPMENT: 28
- ABNORMAL PERMEATE FLOW 30
- SERVICE ASSISTANCE 32
- OPERATION 33
- DRAWINGS 34
- FIGURE 6 35
- FIGURE 7 36
- FIGURE 8 37
- R1-1140 SYSTEM PART LIST 38
- R1-2140 SYSTEM PART LIST 39
- R1-3140 SYSTEM PART LIST 40
- R1-4140 SYSTEM PART LIST 41
- R1-5140 SYSTEM PART LIST 42
- R1-6140 SYSTEM PART LIST 43
- R1-1140 FLOW DIAGRAM 44
- R1-2140 FLOW DIAGRAM 45
- R1-3140 FLOW DIAGRAM 46
- R1-4140 FLOW DIAGRAM 47
- R1-5140 FLOW DIAGRAM 48
- R1-6140 FLOW DIAGRAM 49
Produits connexes et manuels pour Purificateurs d'eau Axeon R1-Series
(45 pages)
(25 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.642 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels